Mitutoyo qm-data 200 Manual

A SERVICE OF

next previous

No. 99MBA038A

4-4

4.2 Selecting and Outputting Required Measurement

Items Only

[Purpose of Practice]

To practice selecting and outputting just the required items as measurement results. In this

section, the point & angle feature formed by two adjacent edges is measured to output only

the intersection angle (A1).

(B)

150°

(A1)

(A)

Fig. 4-2-1

[Operating Procedures]

Table 4-2-1

No. Operation Screen display and remarks

1

Preparing the workpiece

Set the model workpiece on the XY table as shown

below, and focus on it.

–

2

Measurement function selection

Press

.

–

3

Starting output item selection

Press the [F3] function key corresponding to

.

–