A SERVICE OF

logo

Open as PDF
next previous
Page34
7014-179D
December 16, 2011
R
CB 1200 Pellet Stove
2. Exhaust Blower Replacement
G. Igniter Replacement
F. Bafe Removal
1. Usepropershutdownprocedurestoshutdownthe
applianceandletitcompletelycooldownandthen
unplugitandremovetheashdrawer.
2. Followinstructionstoremovetheashpanfoundon
page 30.Removetheaccessplatedirectlyaboveit
byremovingthe2screwsjustbelowtheashcatcher.
3. Thewireleadstotheigniterareconnectedtothewire
harnesswith1/4inchmale/femalespadeconnectors.
Thesewireswillpullforward approximately4to5
inches(102mmto127mm).Disconnectthe spade
connectionsandremovetheigniterfromthechamber.
Loosenthethumbscrewandslideigniterout.
4. Installnewigniterinto thechamberand tightenthe
thumbscrew.Re-connectthewirestothe2leadswith
thespadeconnectors.
5. Removerightsidepanelandpullwireleadsback
towardtherearoftheappliancetotake-upthe4to5
inches(102mmto107mm)previouslypulledout.This
willkeepthewiresoutofthewayoftheashdrawer.
Doublecheckthattheigniterwiresareclearofany
movement,i.e.ashdrawer,repotcleaningrod,etc.
6. Re-installtheashdrawerandsidepanelandre-connect
thepower.
1. Usepropershutdownprocedurestoshutdownthe
applianceandletitcompletelycooldown.
2. Openrightsidepanelandthenopenthedoor.
3. The2bafesarelocatedatthetopinsideofrebox.
4. Placeyourhandonthebafeandslideitupandthe
bottomedgewillfalldownandthenyoucanliftthebafe
out.Repeatfortheotherside.
Igniter
Igniter Bracket
Thumb Screw
Figure 34.1
Remove existing blower:
a. Usepropershutdownprocedurestoshutdowntheappli-
anceandletitcompletelycoolandthenunplugit.
b. Usean11/32"wrenchornutdrivertoloosenandremove
the(6)nutsholdingmotormount plateto theblower
housingonyourstove.
c. Removewasherfrombeneaththeterminalringonthe
groundingwire.
d. Pullmotor/mountingplatefromblowerhousing.
e. Scrapeoffoldgasketingmaterialfromblowerhousing.
Install new blower:
f. Theblowerandblowerhousingisshippedasaunit.It
isnecessarytoseparatethematthispointifyouare
usingtheexistingblowerhousingalreadyinstalledon
theappliance:
g. Followsteps2and3above.Discardorsetasidethenew
blowerhousing.
h. Carefullyremovegasketingfromnewhousingandset
ontotheblowerhousing.
Re-install blower to blower housing:
i. Installbloweronhousingensuringthatwiringexitsfacing
the8o’clockposition.Placethewasherandthenthe
groundingwireonnearestmountingplatestud.
j. Usenutsremovedinstepbtosecureblowertohous-
ing.
k. Re-connectwiring(usejumperwireifnecessary).Re-
connectpowersupply.