Rockwell Automation Publication 1412-UM001D-EN-P - September 2012 15
Chapter 2
Operation
The instrument is turned ON by pressing the green power button. The startup
screen appears and indicates the instrument's software version and serial number.
If there is no AC power supply, the instrument operates on batteries. The
instrument's batteries are charged when it is connected to a 120/240; 60/50Hz
line.
The instrument is turned OFF by pressing the green power button. Power off
confirmation is asked if the instrument is recording or detecting transients.
Instrument Configuration
(Set-up Mode)
This product contains a sealed NiMH battery which is permanently connected and
should only be removed or replaced by trained professionals.
At the end of its life, the battery contained in this product should be collected
separately from any unsorted municipal waste.
The collection and recycling of batteries helps protect the environment and
contributes to the conservation of natural resources as valuable materials are
recovered.
The current probes connected are identified at power ON only. Restart the
PowerPad unit after the probe type is changed.
All configurations are available through the DATAVIEW software.
The instrument must be configured the first time it is used and then whenever
necessary, should your needs change. The configuration is saved in the non-
volatile memory when the instrument is turned OFF.
