Page 6-1
SPIRE III Series – Installation and Operating Instructions
6. operatIon
sequence oF operatIon
Mode Photo Safety Sensor
Clear and No Micro
Switches activated
Photo Safety Sensor
Blocked
Micro-Switch
Activated
Emergency Stop
(E-Stop) Switch
Pressed
RUN
When RUN is pressed,
the rollers rotate at the
set speed.
When the Photo Safety
Sensor is blocked, the
rollers do not rotate
when RUN is pressed.
When the Micro-
Switch
a
is activated,
the rollers do not rotate
when RUN is pressed.
When RUN is pressed,
the rollers do not rotate.
When
machine
is running
The rollers will rotate at
the set speed.
When the Photo Safety
Sensor is blocked when
the machine is running,
the rollers stop.
When the Micro-
Switch
a
is activated
while the machine is
running, the rollers stop.
When an Emergency
Stop Switch (also
referred to as E-Stop) is
pressed while running,
the rollers stop.
Footswitch
is pressed
When the Footswitch
is pressed the rollers
rotate at the set speed.
When the Footswitch
is pressed , the rollers
rotate at 3 ft. (1 meter)
per min.
When the Footswitch
is pressed , the rollers
rotate at 3 ft. (1 meter)
per min. when you
press the Footswitch.
When the Footswitch is
pressed the rollers do
not rotate.
When the Footswitch
is released, the rollers
stop rotating unless
RUN is pressed and the
Footswitch is released.
Once the Photo Safety
Sensor is clear, RUN
is pressed, and the
Footswitch is released,
the rollers rotate at
the set speed without
stopping.
When the Footswitch is
released, the rollers will
stop rotating.
REV
(Reverse
When REV is pressed
and held, the rollers
rotate in reverse at 3 ft.
(1 meter) per min.
When REV is pressed
and held, the rollers
rotate in reverse at 3 ft.
(1 meter) per min.
When REV is pressed
and held, the rollers
rotate in reverse at 3 ft.
(1 meter) per min.
When REV is pressed
and held, the rollers do
not rotate.
When REV is released, the rollers stop rotating.
a. An internal Micro-Switch is activated when the Feed Table is raised.
