PAGE 7/58
TANDBE RG
Telepresence T3
119078.01 TELEPRESENCE T3 SYSTEM ASSEMBLY 12.08
C EIL IN G LI GH T
L IGH T MO UN TI NG DE TAI LS
Remove screw, plastic retainer and alloy protective
guard for wiring access.
Remove screw, plastic retainer and alloy protective
guard for wiring access.
Remove the five wire factory installed lead from the
fluorescent light armature. (This is only used with
dimming) Use a 20cm piece of the three wire lead to
couple the adjacent spot/fluorescentlights together.
There should be many extra meters of the three wire
leads from the spotlights after they are clipped to the
correct length.
Blue=N
Green=GND
Brown=L
The four spotlights and the three fluorescent lights are
physically fastened together with two M4x40 screws
and knurled plastic nuts.
Use the chrome plates to cap off the ends of the far
right and far left spotlight boxes in the two rows of
lights.
