To turn it off quickly: Whatever the
power level, touch sensors and
(2/4) simultaneously and the hob will be
instantly switched off.
If all the hobs are at 0, all the points on the
display will flash.
When turning off a hob, an H will be dis-
played on the corresponding power dis-
play if the hob's glass is at a high tempe-
rature, which can cause burning, . When
the temperature has reduced, the display
turns off (if the stove is switched off). If the
stove is still on then a 0 is displayed.
SWITCHING THE APPLIANCE OFF
The appliance may be switched off at any
time by touching the general on / off sen-
sor (1). When in standby mode, an H is
displayed on any hot areas. None of the
other hotplate displays will light up.
After use, disconnect the device
using the control; do not rely on the
cookware detector.
Locking the hob sensors
The safety function can be activated once
the stove is switched on. To do this, touch
sensor (1) to activate the touch control.
Touch buttons and (2/4) simultane-
ously, followed by the power increase but-
ton (5). An L will appear on the power
displays (3), indicating that the touch con-
trol is locked.
The electronic control will remain locked,
even after switching it off using sensor
(1), until it is unlocked by the user.
Unlock for Cooking
If you wish to unlock the touch control for
cooking, touch sensor (1) to activate it.
Immediately after, touch sensors and
(5/4) simultaneously. The L will no lon-
ger be displayed and the touch control will
operate normally. When the touch control
is switched off using the On/Off sensors
(1), the safety function will be reactiva-
ted and the L will be displayed the next
time the touch control is turned on.
Turning Off the Safety Function
The safety function can be deactivated
permanently, by touching sensors and
(5/4) at the same time, followed by sen-
sor (4), after having switched on the
touch control using the On/Off sensor
(1).
After this, when the touch control is turned
on again by using the On/Off sensor
(1), the hob will be ready to be used. If the
touch control is locked in the event of a
power cut, it will be deactivated.
STOP Function
This function allows you to pause the coo-
king process. If the timer is activated, this
will also be paused.
Activating the Stop Function
1 The pans are on the hobs, which are set
at a specific level
2 Touch the Stop sensor (9). The power
displays (3) will scroll through the letters
S-T-O-P instead of showing the selected
cooking level. Cooking will remain pau-
sed.
Deactivating the Stop Function
1 Touch the Stop sensor (9) followed
by any other button except the On/Off
sensor (1). Cooking will be resumed
GB
22
