SWITCHING OFF QUICKLY
1 Touch the clock sensor (7) many
times as necessary, until the correspon-
ding countdown timer light (13) turns on,
located centrally, below the timer dis-
plays (8).
2 Make sure the decimal point is light (11)
in the indicator (8).
3 Touching the and sensors (5 and
4) at the same time the countdown timer
will switch off..
Touch control user instruc-
tions for all the models
Power supplied according to
the power level selected
Bear in mind that induction areas
adjust the amount of power supplied
according to the size and type (material) of
pan placed on them. A smaller pan will
receive less power than a larger one.
Thus, depending on the pan being used,
the power supplied may vary from the
values shown in Table 1.
Detecting pans
(Induction hotplates)
The induction cooking areas have a built-
in pan detector. This prevents the hotplate
from being left on with no pan on the sur-
face or when the pan is not suitable.
The power display will show the "no pan"
symbol if, when the area is switched on,
it detects that there is no pan or that the
pan is unsuitable.
If a pan is removed from the area while it
is operating, the hotplate will automatically
switch off and the "no pan" symbol will
come on . When the pan is placed back
on the cooking area, it will switch back on
at the power level previously selected.
Pan detection time is 10 minutes. If this
time elapses without a pan or a suitable
pan being put in position, the cooking area
will switch itself off. The power level will go
from showing the "no pan" symbol to
showing 0.
After use, switch the cooking area
off using the touch controls. If not pro-
perly switched off, an undesired use
may be given to the cooking area if a
pan were to be placed inadvertently on
the same area within the following ten
minutes. Avoid possible accidents!
Heat-up
(Starting cooking automatically)
This feature enables you to set the start
time for cooking. The touch control pre-
programs the selected hotplate to maxi-
mum power and then, after a certain time,
reduces it to the power level that you have
selected. (See table 2).
SWITCHING HEAT-UP ON
1 Enable the required hotplate using the
corresponding sensor (2).
2 Use the sensor to select power 9 and
then touch the sensor. An A will be
shown on the display for as long as the
sensor is held down. When you stop
pressing, the power display will alterna-
te between A and 9.
For the 15 seconds after enabling remote
cooking, use the sensor to drop to the
continuous cooking power level that you
want (for example, 6). The display light will
flash on and off, alternating between 6 and A.
25
