selected. The corresponding decimal
point (11) must be lit.
2 Use sensor (4) to decrease the power
to level 0. The hotplate will automatically
switch off.
To turn it off quickly: Whatever the
power level, the hotplate is turned off
immediately if you touch the and
sensors (2/4) simultaneously.
If all the cooking areas are positioned at 0,
all the display points will flash.
When a hotplate is switched off, an H will
appear on the corresponding power dis-
play if the surface of the glass in the
corresponding cooking area reaches a
temperature at which there is a risk of bur-
ning. When the temperature drops, the
display will go out (if the hob is disconnec-
ted), or a 0 is displayed if the hob is still on.
SWITCHING THE APPLIANCE OFF
The appliance may be switched off at any
time by touching the general on / off sen-
sor (1). When in standby mode, an H is
displayed on any hot areas. None of the
other hotplate displays will light up.
After use, disconnect the device
using the control; do not rely on the
cookware detector.
Locking the hob sensors
SAFETY FUNCTION
(models ...635, ...645, ...735 AB and ...622)
The safety function can be enabled after
the hob is connected. To do so, touch sen-
sor (1) to enable the touch control.
Immediately, touch the sensor (4) and
hold it down for five seconds. An L (for
'Locked') will appear on the displays. The
touch control will be switched off after a
few seconds. If the cooking area is hot, an
L and an H will appear alternately on the
corresponding display.
This operation needs to be done within 10
seconds, with no sensor other than those
indicated being touched during that time,
or the locking will not be carried out.
The electronic control will remain locked
until the user unlocks it, even after the con-
trol is disconnected using the sensor
(1) or when restarting after there has been
a power cut.
Unlocking in order to cook
To unlock the control and use it, touch sen-
sor (1) to enable the touch control.
Immediately touch the two sensors on
the right at the same time. The L vanishes
from the displays and a 0 appears with the
lower point flashing, or an H if the corres-
ponding hotplate is hot, and the hob will be
ready to use for cooking. When you switch
off the control using the on/off sensor
(1) the safety function will be re-enabled
and will reappear the next time the touch
control is enabled.
Cancelling the safety function
The safety function can be permanently
disabled by pressing sensor for 5
seconds immediately after enabling the
touch control. This should be done within
10 seconds after enabling the touch con-
trol using the on/off sensor (1), and the
safety function will be cancelled. If this is
not done properly, the touch control will
remain locked and will switch off after 20
seconds.
After cancelling the safety function, when
the control is re-enabled using the on/off
sensor (1), the hob will be ready to be
17
