with the same settings (power levels,
cooking time) as before the pause.
The second button must be pressed within
10 seconds, otherwise the stove will
switch off. If cooking is not resumed within
10 minutes of being paused, the stove will
again switch off.
Function for keeping a pan hot
(models …622)
Using this function, it is possible to keep
food hot in a pan placed on the cooking
area.
1 There is a pan on one of the heating ele-
ments at a previously selected cooking
temperature.
2 It is necessary to touch sensor (4),
after which the symbol will appear in
the indicator. This is a level between the
0 and 1.
To disconnect this function, just touch sen-
sor (4) and change to level 0. This
function will only work for a maximum of
120 minutes, after which the hob will dis-
connect.
Timer function
This function aids the cooking process, as
it is not necessary to be watching: You can
set a hob timer and it will turn off automa-
tically once the selected time has elapsed.
There are 4 lights surrounding the timer
display, showing which of the hobs has a
timer set. For example, if you set a timer
for the upper left hob, the light on the
upper left of the timer display will turn on.
If there are no timers set on any of the
hobs (no hob timer light (10) on), the timer
can be used as a countdown timer (see
section "Countdown Timer").
On these models you can set the count-
down timer and the hob timer from 1 to 99
minutes. All of the hobs can be program-
med independently and operate simulta-
neously.
Timing a hotplate
1 The hotplate to be timed has to be selec-
ted. The corresponding decimal point
(11) must be lit.
2 Select a power level of between 1 and 9
using the or sensors (5/4).
3 Touch the clock sensor (7). The deci-
mal point (11) of the time display (8) will
come on
4 Touch the clock sensor sensor (7)
until the time display of the correspon-
ding hotplate (10) flash on.
5 Now set a cooking time, between 1 and
99 minutes, using the sensors or
(5/4). With the first one you will start with
1, and with the second with 30. Touching
both at the same time the value will
come back to 00.
The clock will begin to control the time
automatically. The control display (10)
corresponding to the timed area will
remain lit up. If you want to set a time for
another hotplate, you have to repeat the 4
and 5 steps.
When the chosen time elapses, the timed
area will switch off and the clock will give a
series of beeps for several seconds. The
time display will show 00 and this will flash
on and off, together with the pilot light of
the hotplate that has disconnected.
If the hotplate that has been switched off is
23
