16
Appendix D Specifications
Inputs: Analog Audio:
1 Single-ended per channel (RCA) on each module type.
1 Balanced per channel (XLR) on each module type.
Input Impedance: 50 KΩ Single-ended or Balanced, for each phase (both modules).
Input sensitivity: Mono Module: (Single-ended) 2.18V RMS input for 225W into 8 ohms.
(Balanced) 1.09V RMS input for 225W into 8 ohms.
Stereo Module: (Single-ended) 1.5V RMS input for 100W into 8 ohms.
(Balanced) 0.75V RMS input for 100W into 8 ohms.
Gain: Mono Module: (Single-Ended) 26dB (20x).
(Balanced) 32dB (40x).
Stereo Module: (Single-Ended) 25.5dB (19x).
(Balanced) 31.5dB (38x).
Polarity: (Single-ended) Non-Inverting.
(Balanced) Pin-2 = Positive, Pin-3 = Negative for Non-Inverting Output.
Outputs:
Analog Audio: 1 balanced output per channel.
I/O RS232: 1 DB9 and 1 RJ45 connector.
Modes/Processes: Standby, Stereo and Surround. Channels may be individually assigned to either buss.
Power Output: Mono Module: (8 ohms-one channel driven) 225 W (rated) 270 W (typical)
(8 ohms-five channels driven) 225 W (rated) 245 W (typical)
(4 ohms-one channel driven) 450 W (rated) 475 W (typical)
Stereo Module: (8 ohms-one to ten channels driven) 100W (rated) 115W (typical)
(4 ohms-one channel driven) 200W (rated) 210W (typical)
Frequency Response: (-3dB points @ full power) 0.3Hz - 250 kHz.
THD+Noise: Mono Module: <1%
Stereo Module: <1.25% (both channels driven into 100W @ 8 ohms).
Signal to Noise Ratio: (unweighted) >100dB
Power Requirements: 117 VAC, 18 amp; 230 VAC, 9 amp; 50-60 Hz; for full power in all channels.
Power Consumption:
No. of 1 ch.
Modules
No. of 2 ch.
Modules
Total no. of
channels
STANDBY IDLE All chs. at rated
power into 8 ohms
Trigger Inputs: 5-12 VDC Pulse between 1 and 500mS.
Dimensions: 17 5/8” W x 8 7/16” H x 23 1/2" D (448 x 214 x 597 mm)
Weight: 98 Lbs. Stand alone (44.5 Kg), 111 Lbs. Boxed with accessories (50.4 Kg)
Maximum Operating Temperature: Internal: 176° F (80° C)
Room: 122° F (50° C)
