SPARC Enterprise M4000/M5000 Servers Product Notes 33
7. Upload the XCP 1050 upgrade image by using the command line getflashimage.
The BUI on XSCFU#0 can also be used to upload the XCP 1050 upgrade image.
8. Update the firmware by using the flashupdate (8) command.
Caution – Flashupdate will update one bank, reset the XSCF and commence
update of the second bank. Verify that the current and reserve banks are both
updated. If both banks indicate XCP revision 1050, proceed to the next step.
Specify the XCP version to be updated. In this examples, it's 1050.
9. Confirm completion of the update.
Confirm no abnormality happens while updating XCSF_B#0.
10. Confirm that both the current and reserve banks of XSCFU#0 display the updated
XCP versions.
If the Current and Reserve banks on XSCF#0 do not indicate XCP revision 1050,
contact your authorized service representative.
11. Turn off all of the server's mainline switches for 30 seconds.
12. After 30 seconds, turn the mainline switches back on.
XSCF> getflashimage http://server.domain.com/XCP1050/images/DCXCP1050.tar.gz
XSCF> flashupdate -c update -m xcp -s 1050
XSCF> showlogs event
XSCF> version -c xcp
XSCF#0 (Active)
XCP0 (Reserve): 1050
XCP1 (Current): 1050
XSCF#1 (Standby)
XCP0 (Reserve): 0000
XCP1 (Current): 0000
