ii
Proprietary Statement
This manual contains proprietary information of Zebra Technologies Corporation and its
subsidiaries (“Zebra Technologies”). It is intended solely for the information and use of
parties operating and maintaining the equipment described herein. Such propriety infor-
mation may not be used, reproduced, or disclosed to any other parties for any other
purpose without the expressed written permission of Zebra Technologies.
Product Improvements
Continuous improvement of products is a policy of Zebra Technologies. All specifications
and designs are subject to change without notice.
FCC Compliance Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provided
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
The user is cautioned that any changes or modifications not expressly approved by Ze-
bra Technologies could void the user’s authority to operate the equipment. This unit was
tested with shielded cables on the peripheral devices. Shielded cables must be used
with the unit to insure compliance.
WARNING: EXPOSURE TO RADIO FREQUENCY RADIATION ON SOME MODELS.
TO CONFORM TO FCC RF EXPOSURE REQUIREMENTS THIS DEVICE SHALL BE
USED IN ACCORDANCE WITH THE OPERATING CONDITIONS AND INSTRUC-
TIONS LISTED IN THIS MANUAL.
Canadian Compliance Statement
"IC:" before the equipment certification number signifies that the Industry Canada techni-
cal specifications were met. It does not guarantee that the certified product will operate
to the user's satisfaction.
Liability Disclaimer
Zebra Technologies takes steps to assure that its published Engineering specifications
and manuals are correct; however, errors do occur. Zebra Technologies reserves the
right to correct any such errors and disclaims liability resulting therefrom.
Limitation of Liability
In no event shall Zebra Technologies or anyone else involved in the creation, production
or delivery of the accompanying product (including hardware and software) be liable for
any damages whatsoever (including, without limitation, consequential damages includ-
ing loss of business profits, business interruption or loss of business information) arising
out of the use of or the results of use of or inability to use such product, even if Zebra
Technologies has been advised of the possibility of such damages. Some jurisdictions
do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you.
Copyrights
The copyrights in this manual and the system described therein are owned by Zebra
Technologies Corporation. All rights are reserved. Unauthorized reproduction of this
manual or the software in any of the system modules may result in imprisonment of up
to one year and fines of up to $10,000 (17 U.S.C.506). Copyright violators may be sub-
ject to civil liability.
©
2004 ZIH Corp. All trademarks and registered trademarks are property of their respec-
tive owners. All rights reserved.
