O-3 UMAN-CM2/3
BATTERIES AND CHARGING
Conditioning Battery Packs
Cameo batteries must be cycled several times before
maximum capacity is realized.
A battery is ”cycled” by fully charging it, then fully dis-
charging it through normal use.
Chargers
Listed below are the specifications for the Cameo
series chargers:
UCN72-4: ( p/n series AC15482-tab)
Designed to charge up to four batteries simulta-
neously. Battery packs may be charged separately
or while plugged into the printer. Typical charge
time is 90 minutes. Switch selectable 110/220
V.A.C. input voltage. Supplied with line cords
compatible with most international standards.
Do not attempt to charge batteries with the UC72-4 Charger
while printing. Attempting to print while charging batteries can
result in unreliable charging.
UCN72-4 part numbers vary depending on specific
country of use. Consult factory for complete part
numbers.
UCN72: ( p/n series AT15244-tab)
A wall mounted single charger with universal 110 to
230, 50-60 Hz. VAC input. Multiple plug configura-
tions comply with most international standards.
Do not attempt to charge batteries with the UC72N Charger
while printing. Attempting to print while charging batteries can
result in unreliable charging.
UC72N part numbers vary depending on specific
country of use. Consult factory for complete part
numbers.