O-18
UMAN-CM2/3
Wireless Communications with Bluetooth™ using
ZBR Radio
The following section only applies when the Bluetooth ZBR Module (FCC ID: I28MD-
BTC2-E) is installed in the Cameo printer (note that only one of the radio options can
be installed in the printer at one time).
“Bluetooth” is a worldwide standard for the exchange of
data between two devices via radio frequencies.
Bluetooth radios are relatively low powered to help pre-
vent interference with other devices running at similar
radio frequencies. This limits the range of a Bluetooth
device to about 10 meters (about 32 feet).
Both the printer and the device it communicates with
must follow the Bluetooth standard.
Exposure to Radio Frequency Radiation
The radiated output power of this internal Bluetooth radio is far
below the FCC radio frequency exposure limits. Nevertheless,
this Bluetooth radio must be used in such a manner that the
antenna is 2.5 cm or further from the human body.
The radio and antenna are mounted internally in this printer such
that when the printer is worn with the back of the printer against
the body and the front of the printer (where paper exits) away
from the body, then the 2.5 cm distance between the antenna
and the users body will be met. Do not use the printer in an
unauthorized manner.
The internal Bluetooth radio operates within guidelines found in
radio frequency safety standards and recommendations. The
level of energy emitted is far less than the electromagnetic
energy emitted by other wireless devices such as mobile
phones.
European Regulatory Information for this Radio
AUS B DK FIN
FDGRIRE
I LUX NL P
ESUK
0682
Important Notice:
This device is a portable RF printer intended for
commercial and industrial use
in all EU and
EFTA member states except in France where
restrictive use applies.
