Chapter 14 Bandwidth Control
GS2200-24 User’s Guide
140
14.3 Bandwidth Control Setup
Click Advanced Application > Bandwidth Control in the navigation panel to
bring up the screen as shown next.
Figure 72 Advanced Application > Bandwidth Control
The following table describes the related labels in this screen.
Table 33 Advanced Application > Bandwidth Control
LABEL DESCRIPTION
Active Select this check box to enable bandwidth control on the Switch.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports.
Use this row first to set the common settings and then make adjustments
on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active Select this check box to activate ingress rate limits on this port.
Ingress
Rate
Active Select this check box to activate egress rate limits on this port.
Egress Rate Specify the maximum bandwidth allowed in kilobits per second (Kbps) for
the out-going traffic flow on a port.
