Chapter 32 Maintenance
GS2200-24 User’s Guide
272
The following table describes the labels in this screen.
32.3.1 Load Factory Default
Follow the steps below to reset the Switch back to the factory defaults.
1 In the Maintenance screen, click the Click Here button next to Load Factory
Default to clear all Switch configuration information you configured and return to
the factory defaults.
2 Click OK to reset all Switch configurations to the factory defaults.
Figure 138 Load Factory Default: Start
Table 87 Management > Maintenance
LABEL DESCRIPTION
Current This field displays which configuration (Configuration 1 or Configuration
2) is currently operating on the Switch.
Firmware
Upgrade
Click Click Here to go to the Firmware Upgrade screen.
Restore
Configurati
on
Click Click Here to go to the Restore Configuration screen.
Backup
Configurati
on
Click Click Here to go to the Backup Configuration screen.
Load
Factory
Default
Click Click Here to reset the configuration to the factory default settings.
Save
Configurati
on
Click Config 1 to save the current configuration settings to Configuration
1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration
2 on the Switch.
Reboot
System
Click Config 1 to reboot the system and load Configuration 1 on the
Switch.
Click Config 2 to reboot the system and load Configuration 2 on the
Switch.
Note: Make sure to click the Save button in any screen to save your
settings to the current configuration on the Switch.
