Chapter 21 Policy Rule
GS2200-24 User’s Guide
178
21.3.1 Viewing and Editing Policy Configuration
To view a summary of the classifier configuration, scroll down to the summary
table at the bottom of the Policy screen. To change the settings of a rule, click a
number in the Index field.
Figure 88 Advanced Application > Policy Rule: Summary Table
The following table describes the labels in this screen.
Add Click Add to inset the entry to the summary table below and save your
changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Cancel Click Cancel to reset the fields back to your previous configuration.
Clear Click Clear to set the above fields back to the factory defaults.
Table 48 Advanced Application > Policy Rule (continued)
LABEL DESCRIPTION
Table 49 Advanced Application > Policy Rule: Summary Table
LABEL DESCRIPTION
Index This field displays the policy index number. Click an index number to edit the
policy.
Active This field displays Yes when policy is activated and No when is it
deactivated.
Name This field displays the name you have assigned to this policy.
Classifier(s
)
This field displays the name(s) of the classifier to which this policy applies.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
