Chapter 3 Using the LCD Screen
V300 User’s Guide
40
1 Select the feature you want to configure. In this example, press MENU to enter the menu
system, then select Adv Setting. In the Adv Setting menu, select DHCP. The following
screen displays.
Figure 8 Example: DHCP
If On appears, the feature is enabled. If Off appears, the feature is disabled.
2 To change the setting, press .
3.3 Entering Numbers, Letters and Symbols
When you enter information into the V300 (when setting up a phonebook entry, for example)
you may need to enter different kinds of characters. The alphanumeric keypad has four input
modes:
• Number mode
• Uppercase mode
• Lowercase mode
• Symbol mode
Use the # key to cycle between modes.
" Not all modes are available in all screens.
When you press a key to enter a character, wait a short time until the cursor moves on to the
next space. Press a key multiple times to access the different characters. For example, in
Uppercase mode press 9 four times to enter “Z”.
The following table shows the numbers, letters and symbols you can enter.
1. DHCP
On
Table 6 Keypad Characters
MODE
Number Uppercase Lowercase Symbol
