Filter
Top Products
You can place or receive calls only within your home area or home affiliated area.
· A-ONLY – A-System Only Mode
The phone will scan the A-system only and prevents switching over to the B-system.
· B-ONLY – B-System Only Mode
The phone will scan the B-systems only.
Note: If your LCD displays “AUTO ROAM ONLY”, your phone has been pre-programmed to operate in the Auto
Roam Mode only.
Enhanced Roaming
Cellular systems are identified by a number called System Identifier or SIS. Your phone is equipped with a Preferred
Roaming List (PRL) which can be programmed by your Carrier to take advantage of the families of cellular system
(SIDs) that your Carrier owns, or has special billing arrangements with, in different cities. In your Home System Area,
both “ ” and “RM” are off in your display. Outside of the Home System in Service Areas closely associated
with your Carrier, the phone’s display may appear the same as when operating in the Home System. In areas where
your Carrier has Roaming agreements, your phone will display a steady “RM” indication. If your display indicates a
flashing “RM”, you are in a cellular system which is not associated with your Carrier (you can still make or receive
calls). If your display indicates a flashing“ ”, you may have to change you’re A/B System Selection or NAM
selection in order to obtain service. If your display indicates , you are in an area where there is no cellular
service.
NAM Selection (F52)
Some cellular users may find it beneficial to register their phones with multiple numbers, for different cities where they
may frequently travel. To provide this ability, your phone has two NAMs (Number Assignment Modules) enabling
up to two registrations.
If you have multiple registrations, the NAM Selection feature enables you to change the NAM being used by your
phone. Do not use this feature, if you do not have multiple registrations.
To change NAMs:
1. Press .
2. You can change the current NAM by or .
3. Press to set.
Force Analog Call (F53)
This feature temporarily directs the phone to use the Analog Mode even if the Digital Mode has been previously
selected.
1. Press .
2. Press when scanning the Analog Mode.
Notes: This feature automatically ends if:
1) The phone is turned off.
2) An outgoing call is made.
3) An incoming call is received.
4) After 10 minutes if items 1) ~ 3) did not occur.