Filter
Top Products
55
Configuring WAP parameters
Select the
Advanced... menu and the Settings menu.
Profiles is used to select or modify your access provider‘s logon parameters or
configure the parameters of other access providers. (The active profile is prece
-
ded with a asterisk).
Configuration of GSM and GPRS parameters:
All information to be entered in the parameters are provided by your operator or
service provider.
On a profile in the list, press
[Options] and select Modify. The different parame-
ters are: Provider title, Home page, Preferred connections , GSM parameters and
GPRS parameters.
Preferred connections:
- GSM if not GPRS (by default): the logon to WAP services uses the GPRS as
a priority. However, in the event of unavailability of the GPRS network, the GSM
network is used to establish the link.
- GPRS: the logon to WAP services uses the GPRS network exclusively.
- GSM: the logon to WAP services uses the GSM network exclusively.
GSM parameters
- User
- Password
- IP address of WAP gateway
- Port type (secure or insecure)
- Dial-up number
- Mode (digital, analog or automatic)
GPRS parameter
- User
- Password
- IP address of WAP gateway
- Port type (secure or insecure)
- APN: if no APN has been defined, press
[Options], then the APN menu.
Select or add an APN.
Once all the settings have been entered, you can activate the chosen service
provider. Select him from the list and validate your choice.
Linger timer: is used to choose the time after which the call is automatically
disconnected if you have forgotten to log off from a service.
WAP Logging on
The connection to a WAP service on the GPRS network is not cut if an incoming
call is received. You can answer the call normally.