Filter
Top Products
3-3
3.5 REMOTE and CONTROL Boards
COVER
GASKET
SHIELD
COVER
PAN HEAD SCREW
M3X6 (9 PCS.)
HANGER GASKET
BINDING SCREW
M4X10 (6 PCS.)
J4
J5
J3
TX/RX BOARD
05P0666
CONTROL CONNECTOR (7P)
REMOTE CONNECTOR (16P)
PAN HEAD SCREW
M3X10
PAN HEAD SCREW
M3X10 (2 PCS.)
PAN HEAD SCREW
M3X8 (5 PCS.)
1
1.Remove cover and shield cover.
2
1. Unplug all connectors from TX/RX Board; dismount the board.
3
1. Mount TX/RX Board.
2. Plug in REMOTE connector and/or CONTROL
connector to TX/RX Board.
3. Attach connectors to the TX/RX Board.
4. Attach shield cover.
4
1. Solder CONTROL Board and/or REMOTE Board to
TX/RX Board.
2. Coat left rear corner and right front corner of CONTROL
and REMOTE Boards with silicone sealant (type KE-
348TRTV, FURUNO code no. 000-801-041).
3. Fasten CONTROL connector and/or REMOTE
connector.
TX/RX BOARD
05P0666
J1
U27 U26
BOTTOM VIEW
BOTTOM
VIEW
3
U26
U27
TX/RX BOARD
CONTROL BOARD
05P0549
REMOTE-A BOARD 05P0457
or
REMOTE-B BOARD 05P0458
PAN HEAD SCREW
REMOTE
CONNECTOR
ASSY.*
CONTROL
CONNECTOR
ASSY.
GASKET
NUT
PLUG
GASKET (3)
FLAT WASHER
* Male and female connector
attached.
TOP
VIEW
J1
J1
U27 U26
J11
J7
J6
J10
J9
J2
J8
J11
J7
J6
J10
J9
J2
J8
J4
1. Attach vinyl tape (approx. 50 mm) to each outside corner of cover.
2. Insert gasket, and then fix it with vinyl tape at corners of cover.
3. Insert main body to cover.
4. Remove vinyl tape.
5. Fasten cover to main body with binding screws.
GASKET
COVER
MAIN BODY
Cover
Groove is outside.
Gasket
Vinyl tape
5
ATTACH VINYL
TAPE
Figure 3-3 Installation of REMOTE and CONTROL boards