Filter
Top Products
3-5
3.8 SW Regulator (SW REG board)
The FS-1503 is supplied with negative ground. If necessary, to float the battery negative line,
the SW REG Kit is available. Install the kit following the illustration below.
J5
J6
2 Fasten SW. REG Board with five
pan head screws-B (M3X8).
J1
J2
J2
J3
SW. REG BOARD
05P0668
J7
PA/FIL BOARD
05P0667
4 Connect CONNECTOR
ASSY. (2 PCS.)
1 Place heat sheet on pedestal.
3 Fasten FETs with
screw-A (M3 x 8).
5 Fasten shield cover
with four screws
(M3 x 6).
Figure 3-5 Transceiver unit, top view, installation of SW REG Board
Contents of SW REG Kit OP05-84 (Code no. 005-939-830)
emaNepyT.oNedoCytQskrameR
GERWS8660P50038-049-5001
.yssArotcennoC001-040HP434-031-0002
teehStaeH02-GFB011-935-0002
wercS6x3M301-188-0004 revocdleihsroF
A-wercS8x3M401-188-0002TEFroF
B-wercS8x3M404-188-0005 bcpGERWSroF
revoCdleihS1411-770-50048-352-0011