Filter
Top Products
LG-SD7130
79
LG-SD7130
78
When showing
symptoms like:
Check this!
If connection is made for a signifi-
cantly long duration, or game and
Internet and others are used for a long
time, the phone may become hot.
This has no effect upon the life of the
product or performance.
When the phone is
heated.
Ringer Type may be set as
"Lamp+Mute". Please select
"Ringer Sound".
When the bell does not
ring, or when lamp or
LCD blinks only.
Because battery wear out, its life grad-
ually becomes shorter. If its life
becomes shorter over half of that at
the time of purchase, you must pur-
chase a new one.
Standby duration
for battery gradually
becomes shorter.
If time for use of battery is short, it may
be due to the user environment, or large
volume of calls, or weak signals.
When usage time of
battery becomes
shorter
If charger blinks while battery is being
charged, it might be that charging
nodes do not have good connection.
Please remove foreign materials from
the nodes from the battery. If the
blinking continues, please refer to
your nearest service center.
If charger’s lamp
blinks when battery
is being charged.
When showing
symptoms like:
Check this!
Check whether it is service area, and if
you continue to see “ ” please turn
off the power and wait for approxi-
mately 2 minutes to turn it back on. If
there is no change, check again after
relocating to other areas.
When “ ” does
not disappear from
the screen.
When frequency environment is unsta-
ble in a certain area, connection may be
abrupt and not audible. Relocate to
other areas and try again.
When connection is
abrupt or is not audi-
ble in certain areas.
When frequency is unstable or weak, or
if there are too many users, connection
may be cut off even after it was estab-
lished. Please try again a little later or
try after relocating to other areas.
When connection is
not made well or
abrupt even when
established.
Remove battery and turn on the power
after placing it back on. If there is no
change even then, sufficiently charge
the battery and try again.
When LCD does not
turn on.
Called "Echo Phenomenon," it occurs
if connection volume is too high or
caused by special properties(semielec-
tronic telephone exchange) of the
machine on the other end.
When it echoes while
connection is made with
a certain telephone in a
certain area.
Before calling for service
Please check to see if any problem which you may
have with your phone is described here before taking
it for service or calling a service engineer.
Chapter 9
Frequently Asked Questions