Filter
Top Products
1514
About the antenna
Your phone has a built-in
antenna. As with any other radio
transmitting device, do not
touch the antenna unnecessarily
when the phone is switched on.
Contact with the antenna affects
call quality and may cause the
phone to operate at a higher
power level than needed. Not touching the antenna
during a call optimizes the antenna performance and
the talk-time of your phone. Normal position: Hold
the phone as you would any other telephone.
Quick Adjust
Adjusting Vibrate Mode
Use Vibrate Mode in a public place.
1) In standby mode, activate Vibrate Mode quickly by
pressing the . (for 2 seconds) instead of
using the Menu function.
▶
When Vibrate Mode is set, Key tone does not
sound.
Note To cancel Vibrate Mode, press for 2 seconds.
Select Profiles
1) In standby mode, press .
2) Select one of four Profiles Silent Mode, Vibrate
Mode, User Mode and Power Mode with .
3) Press .
Adjusting Speaker Mode On
During a call, to activate or cancel Speaker quickly,
press .
Adjusting Keypad Lock Function
Used to lock the keypad and prevent accidental
pressing of the keys. There are two ways to enable the
Keypad Lock Function - with one key and by using the
Menu.
1) In standby mode, set the Key Guard to be enabled
by pressing and holding the key about 2
seconds.
Note To cancel the Keypad Lock Mode, Press Soft
Key 1, then press the star (
*
) key.
Introduction
Basic Phone Operation
Basic Phone Operation
Introduction
Turning the Phone On and Off
Turning the Phone On
1) Install a charged battery pack or connect the
phone to an external power source such as the car
kit or AC Adaptor.
2) Hold down the Key for 2 seconds until the
LCD screen flashes.
Note As any other communication device, avoid any
unnecessary contact with the antenna while
your phone is turned on.
Making a Call
Every time you make a call, follow these steps:
1) Make sure that the phone is turned on. If not, hold
down for 2 seconds.
2) Type the phone number and then press .
▶
If the phone is locked, type the lock code
3) To end the call press .
Note In no service area, appears from the
screen. When trying voice call in no service area,
“Out of Service area”is displayed. It means you
are in no service area.
Receiving Calls
1) When the phone rings or vibrate (if the Vibrate
Mode is enabled), press any key (except ) or
depending on the Call settings.
▶
When you press once, when a call is
received, the phone stops ringing or vibrating
depending on the mode it is in.
2) To end an answered call press .
On pressing the key for the first time, when
the call is received, the phone stops ringing or
vibrating depending on the mode it is in. Pressing
key after that will disconnect the call.
Signal Strength
If you’re inside a building, being near a window may
give you better reception. You can see the strength of
your signal by the signal indicator ( ) on your
phone’s display screen.