Filter
Top Products
Mitel 5603 Wireless Handset User Guide
44
System
Change System
Select “Automatic” or a specific system. If the handset is set to “Automatic” it selects a system
according to the priority list. See “Priority” on page 46.
Subscribe Handset in IP-DECT System using Easy Registration
A handset can subscribe to an IP-DECT system automatically if the following are fulfilled:
• The IP-DECT system is configured for Easy Registration; see the Mitel IP-DECT Base
Station Installation and Operation Manual.
• The handset’s extension number and IPEI are registered in the IP-DECT system, see the
corresponding manual for the IP-DECT system.
• The handset is not subscribed to any systems.
• The handset software is version 4.0.2 or greater.
1. If needed, switch off the handset by pressing .
2. Switch on the handset by pressing .
3. Select language to be used or press "Cancel". If Cancel is pressed, the default language
(English) will be used.
4. The handset starts to search for IP-DECT systems and will subscribe to the system when
it is found.
Notes about Subscribing Handsets and Hot Desking
If the handset is subscribed, but not registered with the MCD or 5000 CP, the handset will
display the following message: "Please login".
• When subscribing the handset to the IP-DECT Base Station, enter the leading 0’s of the
PARK code. Removing the 0’s will prevent subscription.
• After registering the handset with the MCD or the 5000 CP using the System ID, Extension,
and auth password, the "Please Login" message is removed from the handset.
• If you are unable to subscribe the handset, ask the administrator to remove the handset
IPED from the user in the IP-DECT Base Station, if the IPED was pre-programmed for the
user.
If the handset is configured as a Hot Desk handset, then "Please Login" appears for the user
to enter hot desk information.
Note: If no system is found within 2 minutes or "Cancel" is pressed, the handset’s
subscription menu is displayed. Continue with step 5 in the procedure “Subscribe
Handset in IP-DECT System Manually” on page 45 for more information.