Filter
Top Products
NDA-30044 Revision 2.0 Page 3
Location Status Information - User Guide
To Set Location Information (Continued)
The LCD displays: What you do:
When an error message
is displayed:
Enter Date–MMDD To give the date on which you’ll
return:
Enter a two-digit month.
Months 1 through 9 should be
entered “01” through “09”.
Then enter a two-digit day.
Follow the entry with “#”.
To pass over this prompt without
entering a date:
Enter “#”.
To default to today’s date:
Enter “0#”.
Out of Range
=
The month must
lie between 01 and 12. The day
must lie between 01 and 31,
depending upon the number of
days in the designated month.
Enter “#” to display the prompt
again, or press the LSI key to end
the session.
Enter Time–HHMM To give the time at which you’ll
return:
Enter the hour and minute on a
2400 clock, followed by a “#”.
(For instance, 9:00 a.m. is
entered as 0900, and 2:30 p.m.
is entered as 1430.)
To pass over this prompt without
entering a time:
Enter “#”.
Invalid Time=The time must lie
between 0001 (12:01 a.m.) and
2400 (12:00 midnight). Enter “#”
to display the prompt again or
press the LSI key to end the
session.
Enter Phone No To show where you can be reached
until you return:
Enter the complete telephone
number followed by a “#”.
(Note: This number must
include all digits that are to be
dialed, including access code
and area code, and may be as
long as 22 digits.)
To pass over this prompt without
entering a time:
Enter “#”.
Message Set To end the session and clear the
display:
Enter “#”.
If no action is taken, LSI
automatically ends the session
and clears the display.