Filter
Top Products
-6-
OPERATION OF THE PHONE
1) Press the PWR key and hold it for at least 2 seconds.
The phone will carry out a short self-test sequence, then
briefly display an all “8” pattern.
2) When the RSSI Indicator appears on the display, the
phone is ready for use.
If NO SVC appears it means that you are outside the cellular
service area and the network cannot serve you.
A cellular phone can only send and receive calls when it
is switched on.
3) Press the PWR key and hold it for at least 2 seconds to
switch the phone off.
PLACING A CALL
For optimum performance, fully extend the antenna before
sending or receiving a call.
Note: Push in the antenna when you are not using the
phone.
You can use the phone without extending the antenna in a
good coverage area.
1) Key in the number (include the area code if you're
making a long distance call).
If you make a mistake, press the CLR key to delete the last
keystroke; or to clear the whole display, press and hold the
CLR key.
2) The number will appear on the display.
3) Press SND.
4) The IN USE indicator will appear, and the number will
disappear from the display.
5) Lift the phone to your ear, and wait until your call is
answered.