Filter
Top Products
Call functions
Copyright © 2006 Nokia. All rights reserved.
25
1. In the standby mode, press and
hold the right selection key. A
short tone is played, and Speak
now is displayed.
If you are using a compatible
headset with the headset key,
press and hold the headset key
to start the voice dialing.
2. Say the voice command clearly.
If the voice recognition is
successful, a list with matches
is shown. The phone plays the
voice command of the match
on the top of the list. After
about 1.5 seconds, the phone
dials the number. If the result
was not the correct one, select
manually another entry from
the list.
Note: Using voice tags
may be difficult in a noisy
environment or during an
emergency, so you should
not rely solely upon voice
dialing in all
circumstances.
Using voice commands to carry
out a selected phone function is
similar to voice dialing. See “Voice
commands,” p. 57.
■ Answer or reject a call
To answer an incoming call, press
the call key, or open the slide. To
end the call, press the end key, or
close the slide.
To reject an incoming call when
the slide is open, press the end key.
To mute the ringing tone, select
Silence. Then answer or reject the
call.
Tip: If the Divert if busy
function is activated to
divert the calls (for
example, to your voice
mailbox), rejecting an
incoming call also diverts
the call. See “Call,” p. 61.
If a compatible headset supplied
with the headset key is connected
to the phone, press the headset
key to answer and end a call.
Call waiting
To answer a waiting call during an
active call, press the call key. The
first call is put on hold. To end the
active call, press the end key.
To activate the Call waiting
function, see “Call,” p. 61.
■ Options during a call
Many of the options that you can
use during a call are network
services. For availability, contact
your network operator or service
provider.