Filter
Top Products
Nokia Intellisync Wireless Email Linux Installation Guide 37
5 Post-Installation Testing
The following sections provide instructions for testing the system after installation.
End User Web Site
Users can use the Web site to log in, configure their account settings, and install software on
their device.
On the server, open a Web browser and type http://<serveraddress>/. This step validates that the
server is operational and the Web site is available.
If you receive an HTTP error, try the following solutions:
Check the default Web site port and confirm the port is set to 80.
Restart the server.
Administrator Web Site
On the server, open a Web browser and type http://<serveraddress>/admin/. This step validates
that the server is operational and the Web site is available.
If you receive an HTTP error, try the following solutions:
Check the default Web site port and confirm the port is set to 80.
Restart the server.
After you complete these initial tests, the system is ready for user access.
Troubleshooting Logon Issues
If the server does not recognize the account or password, then the logon fails. Make sure you
typed the correct user name (including the domain name) and password, and then try again.
If the user name and password are correct but you still cannot log on, ensure that all Nokia
Intellisync services are started. For instructions to start Nokia Intellisync services, refer to
“Starting and Stopping Services” on page 27.