Filter
Top Products
16/18
7.2.4 Reading Outputs
The Output_Get X commands are used to read digital output states. Note that password
property is set off in following example commands (see Table 6).
Table 6 Output_Get X commands
Command type Command template Comments
Output_Get All
Nokia30 Output_Get All
Response:
OUTPUT_GET ALL: OK
OUTPUT 1: X
OUTPUT 2: X
OUTPUT 3: X
OUTPUT 4: X
OUTPUT 5: X
The X refers to either ON or OFF.
The command reads all outputs
and the response returns the
state of those
Output_Get Z
, Z = 1,2,3,4 or 5
Nokia30 Output_Get Z
Response:
OUTPUT_GET Z: X
The X refers to either ON or OFF.
The command reads output Z (Z
= 1,2,3,4 or 5) and the response
returns the state of it
7.2.5 Writing Outputs
The Output_Set X commands are used to write digital output states. Note that password
property is set off in following example commands (see Table 7).