Nokia 3230 Cell Phone User Manual


 
183Copyright © 2005 Nokia. All rights reserved.
3. The phone starts to search for devices within range. Devices using Bluetooth
technology that are within range start to appear on the display one by one. You
can see a device icon, the device’s name, the device type, or a short name.
Paired devices are shown with . A paired device is one where a Bluetooth
connection already exists between your phone and the other device.
To interrupt the search, press Stop. The device list freezes and you can start
to form a connection to one of the devices already found.
4. When searching for devices, some devices may show only the unique device
addresses. To find out the unique address of your phone, enter the code
*#2820# in standby mode when the Bluetooth connection is active.
If you have searched for devices earlier, a list of the devices that were found
previously is shown first. To start a new search, select More devices. If you
switch off the phone, the list of devices is cleared and the device search needs
to be started again before sending data.
5. Scroll to the device you want to connect with and press Select. The item you
are sending is copied to Outbox and the note Connecting is shown.
6. Pairing (if not required by the other device, go to step 7.)
If the other device requires pairing before data can be transmitted, a tone
sounds and you are asked to enter a passcode.
Create your own passcode (1-16 characters long, numeric) and agree with
the owner of the other device to use the same code. This passcode is used
only once and you do not have to memorise it.
After pairing, the device is saved to the Paired devices view.