Filter
Top Products
Section 2: Understanding Your Phone
2A: Your PCS Phone The Basics 19
Installing the Battery
To install or replace the battery, or to access your phone’s ESN (electronic
serial number), you must first remove the phone’s back cover. To do so,
press the release button, press your thumb against the thumb grip, and
slide the entire back cover up and over the whip antenna.
Tip: Always make sure the power is off before removing the phone cover
Your PCS Phone comes with a Li-Ion battery. Follow these steps to
install it:
1.
Insert the battery at a 45-degree angle with the label side facing up
into the cavity on the back of the phone. The metal contacts must be
aligned with and connected to the metal prongs.
2.
Press down on the battery until it snaps into place.
Removing the Battery
To remove your battery, follow these easy steps:
1.
Make sure the power is off so that you don’t lose any stored numbers
or messages.
2.
Remove the back cover by pressing and holding the release button
and sliding the entire back cover up and over the whip antenna.
3.
Pull upward on the lower end of the battery with your finger tip and
remove the battery from the phone at a 45-degree angle.
Sprint FM OUG NO BROWSER CTIA-3a.book Page 19 Wednesday, October 9, 2002 1:42 PM