Filter
Top Products
12
[ 76 ]
Set automatic answer
This profile lets your phone answer incoming calls after just 1 ring.
Note:
This setting is available only when your phone is connected
to a headset, loopset or to an approved car kit. This feature applies
only to voice calls.
1
Press
Menu
4 6 (
Settings
>
Accessory
settings
).
2
Scroll to
Headset
,
Handsfree
or
Loopset
then press
Select
.
3
Scroll to
Automatic answer
, then press
Select
.
4
Scroll to
On
and press
Select
.
Use the loopset setting
The LPS-3 Loopset gives people with T-coil equipped hearing aids the
ability to make and receive calls without noise interference.
Important:
Refer to the booklet that comes with the LPS-3 for
complete instructions and safety information.
1
Plug the loopset jack into the bottom of your phone.
2
Press
Menu
4 6 3 (
Settings
>
Accessory
settings
>
Loopset
).
3
Scroll to
Use
loopset
, then press
Select
.
4
Scroll to
Yes
, then press
Select
.
Note:
The headset is the default accessory. If you follow steps 1 - 4
above, you set the loopset as the default accessory recognized by
your phone.
Use the car setting
If you are using your phone with a car kit approved by Nokia, you can set
lights to
On
(lights stay on) or
Automatic
(after 15 seconds, lights turn
off until the next key is pressed or the phone rings).
loopset jack