Filter
Top Products
EN 19
En
How to attach the camera table to the digital camera
In order to load the camera into the Case, attach the camera table (located on the front-lid side of the
Case) to the digital camera.
Using the electronic flash
To attach the combination of the FL-20 Electronic Flash and the PFL-01 underwater flash case or the
FL-36 Electronic Flash and the PFL-E01 underwater flash case to this Case, connect the hot shoe cable
provided with the PFL-01 or PFL-E01 to the camera and to the hot shoe cable connector on the front lid
side of this Case as described below. Note that the camera’s built-in flash cannot be used when an
external electronic flash and case are installed. Be sure to set the automatic pop-up setting of the camera
to OFF so that the builtin flash will not pop up automatically.
1 Attach the camera table to the tripod seat section on
the bottom of the digital camera. Use the camera’s
tripod screw hole for attaching.
2 The camera table has fixed up-down and front-rear
orientations. To ensure that it is properly attached,
refer to the illustration on the right.
1 Before loading the camera in the Case, connect the
hot shoe cable’s connector to the Case’s hot shoe
cable connector.
Up
Down
Front
Rear
PT-E03_EN.Book Page 19 Tuesday, March 20, 2007 7:21 PM