Filter
Top Products
EN 29
En
5. Handling After Shooting
Wipe off any waterdrop.
After underwater shooting, remove any drops of water
from the case. Use pressurized air or a soft, lint-free cloth
to carefully wipe away any moisture from the hinge
between the front and rear lids, the shutter release lever,
the handgrip and the buckles.
CAUTION:
• Water left between the front and rear lids or between the case and port can get inside the case once it is
opened or the port is detached. Please dry these areas carefully.
• When opening the case or removing the port, make sure no water from outside (e.g. drops from your hair
or the diving suit) gets inside the case and/or on the camera!
• Before opening the case or removing the port, ensure that your hands or gloves are completely clean (free
of sand, loose fibers, etc.).
• Never open the case or remove the port in areas where water could splash or spray or where sand or dust
could be blown in the air. When this cannot be avoided, for example if the battery or memory card needs to
be changed, the case and camera should be protected from the wind or spray with a plastic sheet or similar
object.)
• Never touch the digital camera and/or battery when your hands are wet with sea water.
Note:
Moisten a cloth or towel with tap water and keep it in a plastic bag. Use this to wipe the salt water or crystals
from your hands before you touch the camera.
PT-E03_EN.Book Page 29 Tuesday, March 20, 2007 7:21 PM