Filter
Top Products
*6 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up
the handset to answer a call, turn off this feature.
*7 If you do not want the unit to ring before the caller information is received, set to “Off”.
(Caller ID subscribers only)
You can only remove the first ring if the unit rings two times or more by default, which
depends on your service provider/telephone company.
*8 The recall/flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
You can access your service provider/telephone company “call waiting” service by having
the recall/flash time set at “100 msec.”, and then follow your service provider/telephone
company “call waiting” instructions to operate this service.
*9 To prevent other users from joining your conversations with outside callers, turn this feature
on.
Special programming
Alarm
An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
Important:
R Set the date and time beforehand
(page 12).
1 M
N
2 MbN: “Handset Setup” a M N
3 MbN: “Alarm” a M
N
4 MbN: Select the desired alarm option. a
M
N
“Off”
Turns alarm off. Go to step 8.
“Once”
An alarm sounds once at the set time.
“Daily”
An alarm sounds daily at the set time.
Go to step 6.
5 Enter the desired date and month.
6 Set the desired time. a M
N
7 MbN: Select the desired alarm tone. a
M
N
R We recommend selecting a different
ringer tone from the one used for
outside calls.
8 M
N a M N
R When the alarm is set,
is displayed.
Note:
R To stop the alarm, lift the handset and
press M
N or place the handset on the
base unit or charger.
R When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Storing an area code to be
deleted automatically
In some situations, phone numbers stored
automatically in the caller list (page 23) will
include area codes. If you do not want to dial
the area code when making calls from the
caller list, you can store the area code which
you want the unit to delete automatically.
Example: You have stored the area code
“123”. If you make a call from the caller list to
the phone number “123-456-7890”, the unit
dials “456-7890”.
1 M
N
2 MbN: “Base Unit Setup” a M
N
3 MbN: “Area Code” a M
N
20
Programming
TG2721_22AL(en)_0730_ver001.pdf 20TG2721_22AL(en)_0730_ver001.pdf 20 2012/07/30 16:53:052012/07/30 16:53:05