Filter
Top Products
Advanced Settings
43
Scroll to Registration and press SELECT.
Scroll to Adv. Settings and press SELECT.
Press to reach the menu list.
Registration
Up to 5 handsets can be registered to the base station.
Warning : If you wish to register non Philips handsets to the DECT 623 or DECT 627 base station,
make sure that this handset is GAP compliant otherwise it will not operate properly (see page 11).
Enter the 4-digit PIN code (by default “0000”) and press OK.
If the registration was successfull, a long confirmation tone is heard and the handset
number (1 to 5) will be assigned by the base automatically.
To register a handset
If you have inadvertently unregistered your handset, you can register it again.
Additional handsets must be registered to the base before use.
To register a handset, first press the paging key on the base for approx. 5 seconds when the
base is in idle mode.Then carry out the following steps on the handset within one minute :
To unregister a handset
Scroll to Unregistration and press SELECT.
Scroll to Adv. Settings and press SELECT.
Press to reach the menu list.
Choose the handset to unregister from the list and press SELECT.
Note : If you have your handset serviced, please make sure it is unregistered from the base station befo-
re taking it back to the repair centre.
Scroll to Reset and press SELECT.
Scroll to Adv. Settings and press SELECT.
Press to reach the menu list.
Select Ye s to reset your phone and press SELECT.
You can reset your phone to the default settings (see page 51) at any time. Note that after a
reset all your personal settings and saved data (phonebook entries, SMS messages,
call log and redial list) will be deleted.
Note : After a reset you need to reconfigure your phone, refer to page 40.
To reset to default settings
DECT623_627_GBIE_part2.qxd 15.07.2005 11:50 Seite 43