Filter
Top Products
7
3. Route the other end of the short
cord through the hole in the
bracket’s center.
4. Attach the supplied bracket to the
bottom of the base by inserting
the tabs on the bracket into the
slots on the base, then sliding the
bracket up.
5. Insert the supplied AC adapter’s
barrel plug into the
12VDC
jack on
the back of the base. Then plug
the adapter into a standard AC
outlet.
6. Plug the modular cord into the
wall plate’s jack.
7. Align the bracket’s keyhole slots
with the wall plate studs and slide
the base downward to secure it.
8. Carefully place the handset in the
cradle at the top of the base and
make sure it is secure.
Note:
If you later want to mount
the base on a desktop, press
PUSH
on the bracket and pull it off
to remove it.
9. Fully extend the base’s antenna
and place it in a vertical position.
Mounting the Base Directly
on the Wall
You need two wood screws (not sup-
plied) for this mounting method.
1. Drill two holes 3
15
/
16
inches apart.
Then thread a screw into each
hole, letting the heads extend
1
/
4
inch from the wall.
43-1031.fm Page 7 Tuesday, August 17, 1999 9:24 AM