Filter
Top Products
8
2. Plug one end of the supplied mod-
ular cord into the
TEL. LINE
jack
on the back of the base.
3. On the bottom of the base, route
the modular cord downward and
under the slot’s clips as shown.
4. Attach the supplied bracket to the
bottom of the base by inserting
the tabs on the bracket into the
slots on the base, then sliding the
bracket up.
5. Insert the supplied AC adapter’s
barrel plug into the
12VDC
jack on
the back of the base. Then plug
the adapter into a standard AC
outlet.
6. Plug the modular cord into a mod-
ular phone line jack.
7. Align the keyhole slots with the
mounting screws and slide the
base downward to secure it.
8. Carefully place the handset in the
cradle at the top of the base and
make sure it is secure.
Note:
If you later want to mount
the base on a desktop, press
PUSH
on the bracket and pull it off
to remove it from the base’s bot-
tom.
9. Fully extend the base’s antenna
and place it in a vertical position.
43-1031.fm Page 8 Tuesday, August 17, 1999 9:24 AM