Filter
Top Products
11
Notes:
• The wall outlet and plug vary according to country.
• It is normal for the battery to become warm during charging.
• When both the front and rear slots are occupied, both slots
are charged at the same time.
• When the temperature is too high or low, the charge lamp
turns to yellow and the battery is in Standby mode until the
temperature returns to normal (5
o
C ~ 35
o
C, 41
o
F ~ 95
o
F).
1. Plug the power cord of the charger
into an appropriate wall outlet.
Result: When the power is connected
properly, the lamp on the charger
flickers red, green, and yellow in
sequence.
2. Remove the battery from the phone
and place it in the rear compartment
of the charger.
Result: The lamp marked BATT on the
front of the charger lights up red.
3. If you do not wish to use your phone
while charging the battery, you can
leave the battery attached to the
phone. Place the phone with the
battery attached in the front
compartment of the charger with the
keypad facing forward.
Result: The lamp marked PHONE on
the front of the charger lights up red.
10
Charging the Battery
When you purchase this phone, the battery is not
fully charged. Please charge the battery fully before
operating the phone.
To Use the Normal Charger (DTC 58)
Preparation
Preparation
Note: If the lamp blinks yellow, the battery pack is not properly
inserted or the contact of the charging terminal is stained or
rusty. When this occurs, remove the battery pack, check the
charging terminal and reinsert the battery pack. If this does not
work properly, replace the battery pack with a new one.
More on Batteries
◆ The lamp color indicates the charging status as follows:
Front (phone charging lamp)
red green
red green
Status
Charging Completed
Slot
Rear (battery charging lamp)
Notes: If both the front and rear slots are occupied, the rear
slot’s charging time is longer.
◆ The full charging time is different according to the battery type
as follows:
Slot
Front FrontRear Rear
100 120
150
180
Time
Battery
Standard Extended
(min)