Sanyo SCP200 Cell Phone User Manual


 
10 11
Charging the Battery
To use the travel charger provided with your phone:
1. Plug the travel charger into a wall outlet.
2. Plug the other end of the travel charger into the
accessories connector at the bottom of your phone,
with the battery installed.
The battery icon appears on the display while
charging.
The battery icon turns to when charging is
complete.
It takes about 3.5 hours to fully recharge a completely
rundown battery.
Tip:You can also see the charging status while the flip is closed. The
red light indicates charging; the green light indicates battery is fully
charged.
Important Note: It is vital that you use only authorized AC adapter
chargers. Use of unauthorized accessories could damage your phone
and invalidate your warranty.
Basics
Using the Battery and Charger
Installing and Removing the Battery
To install:
1. Insert the battery into the opening on the back of the
phone and gently press down until you hear the battery
snap into the place.
2. Place the battery cover into the position as indicated in
the diagram, then slide it until you hear it snap into the
place.
To remove:
1. Make sure the power is off. Press the battery release
latch, then slide the battery cover and remove it.
2. Use your thumbnail to lift and then remove the battery
as indicated in the diagram.