Filter
Top Products
SpectraLink Corporation NetLink e340/h340/i640 Wireless Telephones and Accessories User Guide
Part Number: 72-1004-01-H.doc Page 26
Incoming PBX call
during a PTT call
A telephone call may be answered while in a PTT call session. To
announce an incoming call, the NetLink Docking Station will ring
with a low-volume ring and display the system message.
To answer the call, press the
Start Call button, the SPKR button, or
lift the handset. The PTT call session will be pre-empted and no
PTT audio will be heard.
After the PBX call is over, press the
Start Call button, the SPKR
button,
or hang up the handset as usual to go back on hook, at
which time PTT goes out of pre-empted mode and becomes active
again. If an already active PTT call has not ended, the PTT audio
starts playing again.
If the user does not answer the telephone call by pressing the
Start
Call
button, the SPKR button or lifting the handset, the PTT display
will be shown after the ring has stopped.
Making a PBX call
during a PTT call
To start a telephone call during a PTT call session, press the
Start
Call
button, the SPKR button, or lift the handset. This causes the
two-way radio to be pre-empted as described above.
Docking Station Charging Unit
The docking cradle of the NetLink s340 Docking Station and
NetLink s640 Docking Station acts as a charger for the handset.
This docking cradle is designed to charge the Nickel Metal Hydride
(NiMH) Battery Packs. Full charging is accomplished in
approximately one and a half hours.
See the section Cleaning the Chargers for information on the care of
the docking cradle charging unit in the Docking Station.
Using the docking cradle
Place the NetLink e340/h340/i640 Wireless Telephone into the
Docking Station slot facing forward. When the handset is turned on
and correctly inserted, the
Use Deskset display will appear and
functionality will be transferred to the NetLink Docking Station.
The handset will immediately begin charging.
You can place the handset in the docking cradle while in a call and
the call is transferred to the NetLink Docking Station, in
speakerphone mode (as shown by the
SPKR LED lighting up). You
can then lift the handset to continue the conversation over the
handset if desired.
Charging indicator
If the handset is in standby mode, it will display
Use Deskset and
Charging. . .. If the handset is turned off, only Charging. . . will
display. The dots will be racing during the charging cycle. It is
normal for the Battery Pack to become warm when charging.
Charge Complete
When the handset is fully charged,
Charge Complete will replace the
Charging. . . indicator.
Melody
If the handset is off when placed in the docking cradle, it will
charge. A melody is played after the handset is powered on for the
first time following a completed charge (Charge Complete).