Filter
Top Products
SpectraLink Corporation NetLink e340/h340/i640 Wireless Telephones and Accessories User Guide
Part Number: 72-1004-01-H.doc Page 32
NetLink Quad Chargers
NetLink Quad Charger NetLink Quad Charger
Model GCN100 Model GCX100
(shown with four empty charging bays) (shown with two empty charging bays)
Overview
The NetLink Quad Charger is designed to simultaneously charge
four Nickel Metal Hydride (NiMH) Battery Packs. Model GCX100
is designed to charge the BPX100 Battery Pack for the NetLink
i640 Wireless Telephone. Model GCN100 is designed to charge the
BPN100 Battery Pack in the NetLink h340 Wireless Telephone.
Full charging is accomplished in approximately one and a half
hours.
Power supply
Set up the Quad Charger by first obtaining the appropriate
SpectraLink electrical supply for the country or region. Place the
Quad Charger on a flat, horizontal surface and plug the power
supply into the Quad Charger and into an appropriate wall outlet.
Removing and replacing a
Battery Pack
To remove the Battery Pack from the NetLink i640 Wireless
Telephone, hold handset in one hand with the keypad facing up.
Press both battery release buttons on the left and right sides of the
handset at the same time. The Battery Pack will release downward.
You may catch it with the palm of your other hand. If the Battery
Pack does not release, gently shake the handset while pressing both
release buttons. Do not pry.
Remove the Battery Pack from the NetLink h340 Wireless
Telephone by pressing down on the latch on the Battery Pack on
the back of the handset. The Battery Pack releases outward.
Insert the Battery Pack into one of the four charging bays so that
the Battery Pack contacts meet the charging bay contacts. The LED
above the charging bay will turn on to indicate that charging is in
progress. Complete charging occurs in one and a half to two hours.
When charging is complete, the LED will turn off. Lift the Battery
Pack out of the charging bay.
Blinking LED
If the LED starts blinking as soon as the Battery Pack is inserted,
the Battery Pack may be improperly seated. Lift it out and reinsert.
If the LED continues to blink or starts blinking at any time during
the charging process, it indicates that there is a problem with the
Battery Pack that makes it unusable. Do not continue to charge the
Battery Pack. Dispose of it properly and do not attempt to use it in
the handset. Do not attempt to open or repair a defective Battery
Pack. Contact your service representative for assistance.
To place the Battery Pack into the NetLink i340 Wireless
Telephone, slide the Battery Pack straight into the cavity until it
snaps into place. You should not have to force it against the
handset.