Filter
Top Products
This is the Internet version of the user's guide. © Print only for private use.
27
Calling
To reject a call using voice
commands
When the phone rings, say “Busy”.
The call is rejected. The caller is forwarded
to voicemail, if activated, or hears a busy tone.
Editing your voice commands
You can keep all your voice commands up to date
by rerecording them or deleting the ones you do not
use. You can also edit a voice command for a phone
number in the phonebook. Select the contact you
want to edit a voice command for } More
} View & Edit. Scroll to the relevant tab and edit
your voice command.
To rerecord a voice command
1 } Settings } the General tab } Voice control
} Voice Dialing } Edit Names.
2 Select a voice command } More
} Replace Voice.
3 Lift the phone to your ear, wait for the tone
and say the command.
Tips when recording and using voice
commands
If your phone cannot detect speech, one of the
following might have happened:
• You spoke too softly – try speaking louder.
• You held the phone too far away – hold it as you
do during a call.
• The voice command was too short – it should
be around one second long and more than one
syllable.
• You spoke too late or too soon – speak
immediately after the tone.
• You did not record the voice command when the
handsfree was attached – for voice control with
a handsfree kit, record when the handsfree
is attached.
• You used another intonation – use the same
intonation as you did when recording the voice
command.