TrekStor 4.7 Cell Phone User Manual


 
EN
19
You must have a Microsoft account and be signed in with it
Ideally, you will have created a Microsoft account or signed in with your existing
Microsoft account during the initial setup process when you first switched on
your mobile phone. In this case, all you have to do is open the Windows Phone
Store, select the desired app and tap "
inStaLL" or "Buy".
If you do not yet have a Microsoft account or are not signed in with it, you must
perform these steps. To do this, open the Windows Phone Store and select the
desired app. Tap the app and then tap "inStaLL" or "Buy". An assistant now appears
to guide you through the process of setting up a Microsoft account.
12) Transferring files between the mobile phone and other
devices
Transferring files via Bluetooth
a) Activate the Bluetooth function on the device you want to connect and
make the device visible to other devices, if necessary. To do so, refer to the
operating instructions of the device you would like to connect.
b) Swipe your finger from the top of the screen to the bottom and tap "
aLL
SettingS" "BLuetooth".
c) Move the slider for Bluetooth from "
oFF" to "on".
d) Select the device you would like to connect from the list of devices available
by tapping the name of the device.
e) The mobile phone sends a verification code to the device to be connected.
Check that the code displayed on the device to be connected matches the
code displayed on the mobile phone and confirm with "
[Ja]" on the mobile
phone.
f) You may also have to confirm the pairing procedure on the device to be
connected.
j) The status message "
connecteD" appears under the selected device after
successful pairing.
i
After a successful file transfer, deactivate the Bluetooth function on the mobile
phone (and your destination device) to save energy.