Filter
Top Products
3
Installing the Belt Clip
Line up the tabs with the holes on each side of
the handset. Press the belt clip down until both
tabs click into place.
To remove the belt clip, pull both sides of the clip
to release the tabs from the holes.
Installing the Optional Headset
Your phone may be used with an optional headset.
To use a headset, insert the headset plug into the
headset jack. Headsets may be purchased by
calling the Uniden Parts Department. See back
cover page for contact information.
Charging the Accessory Handset
The handset is powered by a rechargeable battery pack that
automatically recharges when the handset is placed in the
charger.
Connect the AC adapter to the DC IN 9V jack and to a 120V
AC outlet that is not controlled by a wall switch.
Caution: Use only the Uniden AD-0005 adapter.
Set the charger on a
desk or tabletop, and
place the handset in the
charger with the keypad
facing forward.
Make sure that the
charge LED illuminates.
If the LED does not
illuminate, check to see
that the AC adapter
is plugged in and
the handset makes
good contact with the
charging contacts on
the charging cradle.
Charge the handset battery pack for at least 15-20 hours
before using your new handset for the rst time.
1)
2)
3)
4)
Route the
cord.
To AC outlet To DC IN 9V
AC adapter (supplied)
Route the
cord.
To AC outlet To DC IN 9V
AC adapter (supplied)