Filter
Top Products
21
Itad Operation
2. Press REC/MEMO ,”Now recording”, is announced, followed by a beep. Speak towards the
front of the Answering System (max. length: 90 seconds).
3. Press any MAILBOX key to stop the recording.
4. Your outgoing message is played for you, followed by a beep.
5. To review a recorded announcement, press MENU key until “Set Outgoing Message” is
announced. Press any MAILBOX key. The current greeting is played.
6. To delete a recorded announcement, press DELETE during OGM playback. You then hear
“Outgoing Message has been erased”.
NOTE:
If your recording time is less than 2 seconds, your OGM will not be recorded, and the default
greeting will be used.
Set Security Code
The security code programmed into the Answering System is used to gain access to functions
from remote locations. The security code default setting is 19. You can select any two-digit
code, from 00 to 99.
ANSWERING SYSTEM SETUP
NOTE:
In Announce Only mode, your outgoing an-
nouncement is repeated before hanging up.
Recording / Playing / Deleting the Out-
going Messages (OGM)
1. Press MENU key until the desired item
(Set Outgoing Message) is announced.
1. Press MENU unit you hear “Set security
code.”
2. Press TIME/SET to hear the current sec-
urity code.
3. Press SELECT briefly to increase the sec-
urity code by 1. Or, hold SELECT contin-
uously to increase the code by multiples
of 10.
4. Press TIME/SET to confirm your choice
and you will hear the announcement of
the security code.