1-4 C
HAPTER
1: O
VERVIEW
Figure 1-2 CS/2500 Series Enclosure
Hardware Interrupt
Switch
The hardware interrupt switch is located on the server’s left side panel
close to the rear, as shown in Figure 1-2. The switch is recessed behind a
small round hole to protect it from being pressed unintentionally.
Pressing this switch generates a nonmaskable interrupt (NMI), aborting
application software, disabling all ports except the console port, and
passing control to the monitor utility. For information on the monitor
utility, refer to Chapter 4, “Configuration,” and Appendix C, “Monitor
Utility.”
If the server crashes or stops working entirely, you may need to use the
hardware interrupt switch to reboot or to perform a memory dump. For
more information concerning memory dumps, refer to Chapter 6,
“Troubleshooting.”
3Com
CS/2600
Reset switch
Power supply module
Hardware
interrupt
switch
Air intake
Diskette drive
(CS/2600 only)
Air exhaust
Printer port
Transceiver connector
LED indicators
Serial ports
CS2500BookFile : Overview Page 4 Thursday, December 11, 1997 10:44 AM
