Changing the Configuration 4-5
*Default.
† Default for CS/2500.
‡ CS/2600 only. Default is Floppy then Network.
** Choosing TFTP adds a choice to the Change Parameters menu. For more information, see
“Using TFTP” on page 4-9.
(continued)
4. Auto-reboot m - Boot monitor
u - Upload then reboot
r - Reboot only
*
5. Monitor d - Disable
*
e - Enable
6. Initial boot source 1 - Network
†
2 - Monitor
3 - Local Floppy
‡
4 - Network then Floppy
‡
5 - Floppy then Network
‡
7. Number of reboots Reset reboots number
r - reset
8. Network boot string _cs200
*
9. Boot retries 0 - Try One Time
F - Try Forever
*
A. Boot protocol B - BTP Boot
S - SLP Boot
*
T - TFTP Boot
**
B. Change IP/TFTP parameters This option appears only when the boot
protocol is TFTP. See “Using TFTP” on
page 4-9.
P. Printer setup menu 1 - Issue a LF after CR
2 - Do not issue a LF after CR
3 - Add a printer setup string
4 - Delete printer setup string
S. System default configuration
menu
1 - Change default memory map to
CS/2000/2100
2 - Configure port(s) as RS-232
3 - Configure port(s) as RS-422
4 - Enable/Disable automatic RS-422 port
selection (pin 25)
Table 4-1 Firmware Configuration Parameters (continued)
Parameter Values
CS2500BookFile : Configuration Page 5 Thursday, December 11, 1997 10:44 AM
