Changing the Configuration 4-9
If you change the Boot Protocol parameter from TFTP to SLP and back
to TFTP, check the Change IP/TFTP Parameters menu’s Address
Discovery Protocol field. Changing from TFTP to SLP and back to
TFTP results in Address Discovery Protocol reverting from your
configured setting to its default setting (BOOTP then RARP).
Using TFTP
Because TFTP is a file transfer protocol, it must work in conjunction
with a boot protocol to perform the boot procedure. When you specify
TFTP as the boot protocol, you must configure several additional
parameters. These parameters include Address Discovery Protocol, to
specify the boot protocol, and others to specify IP addressing
information.
To specify TFTP parameters:
1 Type
T
for TFTP from the Boot protocol submenu.
The Change Parameters display reappears, with a new option, B, for
IP/TFTP parameters:
2 Type
B
.
The Change IP/TFTP Parameters menu appears:
Current Parameters:
1. Console baud rate 9600
2. Console port 0
3. Continuous self-test Disabled
4. Auto-reboot Reboot only
5. Monitor Enabled
6. Initial boot source Floppy then Network
7. Number of reboots 00
8. Network boot string _cs200
9. Boot retries Try Forever
A. Boot protocol TFTP
B. Change IP/TFTP parameters
P. Printer setup menu
S. System default
configuration menu
esc Return to previous menu
Select parameter ?
Change IP/TFTP parameters:
CS2500BookFile : Configuration Page 9 Thursday, December 11, 1997 10:44 AM
